Assembly - Star Trac Upright Sport Bike Owner's Manual

A
SSEMBLY
Use the following steps to assemble your Sport Bike. Refer to A
8 for illustrations of the hardware used during assembly.
Assembling the Upright Bike
Use the following steps to assemble the Upright Sport Bike.
1. Install Neck assembly
Slide the neck shroud onto the neck assembly. Mate the neck assembly cable con-
nector with the cable in the Sport Bike frame, then carefully slide the neck assem-
bly into the frame.
C
AUTION
neck assembly into the frame.
Secure the neck assembly to the frame using the two screws and washers provided.
Remove the protective film covering the label and keypads on the Sport Utility Display.
2. Insert Seat
Slide the seat assembly through the seat
shroud and into the frame. Pull the height
adjustment knob out to allow the seat to
slide into the frame, then release the knob.
3. Attach rear leg
Position the rear leg on the Sport Bike
frame, and secure in place with the two
screws provided.
4. Install pedals
Using a 15 mm Combo Wrench, install the
pedals onto the pedal crank and tighten
securely (note that the left pedal is reverse
threaded).
5. Leveling the unit
If necessary, level your Sport Bike using the
two eccentric pads located on both ends of
the rear leg. Raise the rear of the Sport Bike
and rotate the eccentric pads as needed.
6
: Exercise care to avoid pinching the cables when installing the
STAR TRAC SPORT BIKE O
M
SSEMBLY ATERIALS
' M
WNER S ANUAL
on page