Ball Oilers - Grizzly G9249 Owner's Manual

Ball Oilers

Lubricant frequency
iso 68 sAe every 8 hours
20W Bearing and of operation
gear lubricant
Wipe clean and lubricate the ball oilers shown in
figures 85–88. to insert the oil, depress the ball
with the tip of an oil can and squirt once.
figure 85. Cross and compound slide ball oilers
(7 total).
saddle Way
figure 86. saddle way ball oilers (4 total).
Ball oilers
figure 87. leadscrew and feed rod ball oilers (2
total).
-50-
Qty
1 squirt
from oil can
Cross slide
Ball oilers
Compound slide
Ball oilers
Ball oilers
Ball oilers
figure 88. tailstock ball oilers.
NOTICE
follow reasonable lubrication practices as
outlined in this manual for your lathe. failure
to do so could lead to premature failure of
your lathe and will void the warranty.
Back Gear Shaft
Lubricant
Multi-purpose gear
grease
Add one pump from a grease gun to the back gear
shaft grease fitting shown in figure 89.
figure 89. Back gear shaft grease fitting.
g9249 12" x 37" Belt drive gap Bed lathe
frequency Qty
every one
40 hours pump
of operation
grease Fitting