Grizzly G9249 Owner's Manual page 51

feed Rate Gears
Lubricant
Multi-purpose gear
grease
To lubricate the feed rate gears:
1.
use a 5mm hex wrench to remove the four
cap screws securing the feed rate gearbox
cover (see figure 83).
Cap
screws
(2 of 4)
figure 83. Feed rate gearbox cover.
2.
Carefully pull the cover from the machine tak-
ing care not to bend the aligning pins.
3. use a brush to apply a thin coat of grease to
the gear teeth.
4. use the aligning pins to properly position the
cover on the machine, then secure it with the
four cap screws.
g9249 12" x 37" Belt drive gap Bed lathe
frequency Qty
every As
40 hours need-
of operation ed
Aligning pins
Apron Gearbox
Lubricant
iso 68 sAe 20W
Bearing and gear
lubricant
remove the oil plug on top of the apron shown in
figure 84, add lubricant, then replace the oil plug.
the apron gearbox reservoir holds approximately
3/4 of a pint of lubricant. excess lubricant will leak
from the front of the apron.
Ball oilers
figure 84. Apron lubrication points.
frequency Qty
every As need-
40 hours ed
of operation
oil plug
-49-