Follow Rest; Cross Slide - Grizzly G9249 Owner's Manual

follow Rest

the follow rest shown in figure 44 is mounted on
the front of the saddle and follows the movement
of the tool along the length of the workpiece. the
follow rest is used on long, slender parts to pre-
vent flexing of the workpiece from the pressure of
the cutting tool. the follow rest requires only two
fingers as the cutting tool acts as the third.
Cap
screws
figure 44. Follow rest mounted on the saddle.
the follow rest is installed/removed with two cap
screws at the base. the fingers are set against
the workpiece in the same manner as those of the
steady rest. Always lubricate the finger tips with
an anti-seize grease during operation.
-32-

cross Slide

Handwheel Dial Increments
upper Marks .............................................. 0.002"
lower Marks ........................................... 0.04mm
the cross slide sits directly on the saddle and
moves perpendicular to the spindle center line
when the handwheel is rotated (see figure 45).
figure 45. Cross and compound slides.
the cross slide graduated dial is a "direct read"
dial. the actual distance the cross slide moves is
⁄ of the dial reading, but removes the amount the
1
2
dial indicates from the diameter of the workpiece.
g9249 12" x 37" Belt drive gap Bed lathe
Resolution
Cross
slide
Compound
slide
handwheels