Ball Oilers - Grizzly G0600 Manual Insert

Ball Oilers

This lathe has 11 ball oiler locations. To lubricate
ball oilers, clean the outside of the ball oiler, push
the ball with the tip of the oil can nozzle and squirt
one or two drops of oil inside the oiler before and
after using the lathe. If the shop environment has
high moisture or is very dirty, increase the oiling
interval. Use the same oil as you are using for the
headstock. The locations listed below show the
ball oilers in Figures 95 to 94:
Figure 94. Cross slide leadscrew end bearing
ball oiler location: 1 ball oiler on the cross slide
lead screw end cap.
Figure 92. Apron and slide ball oiler locations:
4 ball oilers on the compound rest, 1 ball oiler
on the cross slide handle hub, 1 ball oiler on the
apron feed handle hub.
Figure 95. Tailstock ball oiler locations: 1 ball
oiler on the tailstock handwheel hub and
2 ball oilers on the tailstock housing top.
Figure 93. Cross slide ball oiler location: 1 ball
oiler on the cross slide.
-55-
G0600 20" x 60" Big Bore Lathe