Maintenance; Troubleshooting - Royal Sovereign RSC-880LS Owner's Manual

Cleaning the Body of the laminator
1.To clean the machine body, dampen a cloth with water only and gently wipe the
machine clean.
Removing Adhesive Build Up
1. Remove the film from the laminator.
2. Use a damp (water only) cloth and a rubber gum eraser to remove the adhesive on the Teflon (metal) and
silicone rollers.
Note: Rub firmly but do not scrub the rollers vigorously as this may scratch the surface. Do not use sharp
metal objects, steel wool, or abrasives, as these
may also damage the rollers.
Lubrication
1. Drive chain and sprockets should be lubricated with either a light coat of gear lube or heavy grease (lithium
grease) after 6 months or 1000 hours of operation, whichever comes first.
Symptom
Machine will not turn on:
There is power, but the
rollers are not turning
after the "RUN" button
is pressed:
The unit is not heating
up:
Curled lamination:

13. MAINTENANCE

14. TROUBLESHOOTING

Cause
a. Power plug is not plugged in.
b. Power switch is in "0" (Off) position.
c. Tripped circuit breaker.
d. Blown main power fuse.
a. Emergency switch(es) is (are) engaged.
b. Paper guide is not installed correctly.
c. Blown motor fuse.
a. Did not raise the temperature.
a. Upward curl.
b. Downward curl.
RSC-LS/LSH SERIES
a. Plug the power cord into appropriate outlet.
b. Put the power switch to the "I" (On) position.
c. Reset the circuit breaker.
d. Replace the fuse.
a. Disengage the emergency switch(es).
b. Properly install the paper guide so that the micro
switch is activated.
d. Replace the motor fuse.
a. Raise the temperature.
a. Loosen the top roll film tension.
b. Loosen the bottom roll film tension.
14
Possible Solution