Using Cross Cutter - Royal Sovereign RSC-880LS Owner's Manual

The cross cutter is located on the rear exit table of the machine.
1. After lamination, move the cutter approximately to the center of
the completed application at the desired point of detachment
(Figure 1).
2. Grasp film with one hand, press the cutter downward into the
application and slide it first to one end of the application, then to
the other end to complete the cut (Figure 2 & 3).

9. USING CROSS CUTTER

8
RSC-LS/LSH SERIES
Figure 1
Figure 2
Figure 3