Table of Contents
Advertisement
You can disable the indicator LED with the QR-coded parameter menu or configuration software. Regardless of such
setting, however, the indicator LED comes on when:
- you are setting parameters with the QR-coded parameter menu,
- the scanner receives an LED-ON command (LB, LG or LR) from the host PC (refer to Appendix 2),
- the configuration software starts up or any setting is newly established,
- the scanner reads a batch-process QR code,
- the parameter values are saved by a PW command (refer to Appendix 2),
- a master code is being registered or the registration is completed,
- any error occurs during registration of a master code,
- the verification result is a mismatch, the scanner is locked or no master data has been registered in the Data Verification
mode,
- data transfer has been completed or there is no previous data to be retransferred using the data retransfer function,
- data transfer has been completed by the specific character transfer function,
- the setting status of the readable code switching function is displayed,
- you press the magic key that has been disabled by a control command (refer to Appendix 2) specifying any trigger switch
operating mode other than Continuous Reading modes 1 and 2 even though the ready/standby switching function has
been assigned to the magic key,
- the setting status of the Barcode Reader mode switching function is displayed, and
- a hardware error has occurred.
32
Advertisement
Table of Contents
