Table of Contents
Advertisement
The indicator LED can be disabled with the bar-coded parameter menu or configuration software (ScannerSetting). In
any of the following cases, however, the indicator LED comes on regardless of the current LED setting:
- When the scanner is being customized with the bar-coded parameter menus (Chapters 13 and 14).
- When the configuration software (ScannerSetting) starts up or accepts any new setting.
- When a batch-process bar code symbol is read.
- When a master bar code is being registered or the registration is complete.
- When any error has occurred during entry of a master bar code.
- When the verification result is a mismatch, the scanner is locked, or no master data has been registered in the data
verification mode.
- When data retransfer with the magic key is complete or the previously sent data is not available at the time of data
retransfer.
- When specific character transfer with the magic key is complete.
- When a hardware error has occurred.
- When the scanner has failed to save setting.
®
- When the Bluetooth
- When the parameter transfer status from the scanner to the Bluetooth
- When the charge of the battery cartridge has lowered.
- When the charging/discharging state is displayed.
9.3
Vibrator
The bar-coded parameter menu and configuration software (ScannerSetting) provide three configuration choices:
indicating successful scanning (OK), indicating an error (NG), and disabled.
"OK" vibrations: The vibrator operates to indicate any of the following OK conditions.
• Successful transmission of the bar code data just read
• In data verification mode, successful registration of master data
• In the data verification mode, a match between the bar code data just read and master data registered
• End of data transmission started by the data transfer or specific character transfer function
• Scanning of "Start setting," "End setting," or parameter setting bar code from the bar-coded parameter menu
(Chapters 13 and 14)
• Start or end of parameter setting with the configuration software (ScannerSetting)
• Scanning of a batch-process bar code symbol generated with the configuration software (ScannerSetting)
"NG" vibrations: The vibrator operates to indicate any of the following failure conditions.
• Wrong check digit(s) with check digits enabled
• Wrong number of digits in data for new master data registration
• In data verification mode, a mismatch between the bar code data just read and master data registered
• Editing error in the specified data editing, resulting in no transfer
• No ACK response received in the ACK/NAK mode
Note: It is recommended that the vibrator be disabled when the scanner is stationary to a stand.
wireless link status is displayed.
®
adapter is displayed.
38
Advertisement
Table of Contents
