Denso GT10B-SB User Manual page 73

Standard 2of5
Items
Scanning Standard 2of5
Minimum number of digits readable
for Standard 2of5
Maximum number of digits readable
for Standard 2of5
Transmission of a check digit
for Standard 2of5
Specification of the number of digits for
Standard 2of5, by bar code scanning
Interleaved 2of5
Items
Scanning Interleaved 2of5
Minimum number of digits readable
for Interleaved 2of5
Maximum number of digits readable
for Interleaved 2of5
Transmission of a check digit
for Interleaved 2of5
Specification of the number of digits for
Interleaved 2of5, by bar code scanning
Codabar (NW-7)
Items
Scanning Codabar (NW-7)
Minimum number of digits readable
for Codabar (NW-7)
Maximum number of digits readable
for Codabar (NW-7)
Transmission of a check digit
for Codabar (NW-7)
(Note 2) The setting range differs from the number of digits that the scanner can actually read.
(Note 3) To enable the transmission of a check digit, it is also necessary to select the "Enable, with C/D" parameter
for scanning.
Parameters
Enable, without C/D
Enable, with C/D
Disable
1 to 99 digits
Enable
Disable
Enable
Disable
Parameters
Enable, without C/D
Enable, with C/D
Disable
2 to 99 digits
Enable
Disable
Enable
Disable
Parameters
Enable, without C/D
Enable, with C/D
Disable
3 to 99 digits
(including start/stop codes)
Enable
Disable
: Can be changed only with the configuration software.
56
Defaults Refer to:
√
3 digits
(See Note 2.)
99 digits
√
Section 10.2.1 (5)
(See Note 3.)
Section 7.2
√
Defaults Refer to:
√
4 digits
(See Note 2.)
99 digits
√
Section 10.2.1 (5)
(See Note 3.)
Section 7.2
√
Defaults Refer to:
√
4 digits
(See Note 2.)
99 digits
√
Section 10.2.1 (5)
(See Note 3.)