Mounting to Shop Floor
Mounting to Shop
Floor
Bolting to Concrete Floors
Figure 12
NOTICE
Anchor studs are stronger and more per-
manent alternatives to lag shield anchors;
however, they will stick out of the floor,
presenting a tripping hazard if you decide
to move your machine.
Figure 12
NOTICE
Since your dust collection system will be
hardwired to the power source, we strongly
recommend securing your machine to the
floor. Consult with your electrician to ensure
compliance with applicable codes.
Assembly
To assemble the dust collector:
1.
fasteners
Figure 13
Note: To make the installation of the fasten-
ers easier, use scrap wood to raise the metal
components off the floor.
Figure 13.
2.
Step 1
5
Note: The
⁄
fender washers with a larger
16
outside diameter will be used to attach the
canister filters in later steps—do not use
them for any other assembly.
only finger tighten the