Table of Contents
Advertisement
8.1 Introduction
The PCM-5864/E/L is equipped with a high-performance 32-bit
Ethernet chipset which is fully compliant with IEEE 802.3 100
Mbps CSMA/CD standards. It is supported by major network
operating systems. It is also both 100Base-T and 10Base-T
compatible. The medium type can be configured via the
82558.exe program included on the utility disk.
The Ethernet port provides a standard RJ-45 jack. The network
boot feature can be utilized by incorporating the boot ROM image
files for the appropriate network operating system. The boot ROM
BIOS files are combined with system BIOS, which can be
enabled/disabled in the BIOS setup.
8.2 Installation of Ethernet driver
Before installing the Ethernet driver, note the procedures below.
You must know which operating system you are using in your
PCM-5864/E/L, and then refer to the corresponding installation
flow chart. Then just follow the steps described in the flow chart.
You will quickly and successfully complete the installation, even
if you are not familiar with instructions for MS-DOS or
WINDOWS.
Note:
8.2.1 Installation for MS-DOS and Windows 3.1
If you want to set up your Ethernet connection under the MS-DOS
or Windows 3.1 environment, you should first check your server
system model. For example, MS-NT, IBM-LAN server, and so on.
Then choose the correct driver to install in your panel PC.
The installation procedures for various servers can be found on
CD-ROM. The file path begins as:
82
PCM-5864/E/L User's Manual
The windows illustrations in this chapter are
examples only. You must follow the flow chart
instructions and pay attention to the instructions
which then appear on your screen.
Advertisement
Table of Contents
