6.1 Introduction
The PCM-5864/E/L's on-board Video-in and Video-out (TV-out)
provides NTSC and PAL video standards. Video-in uses Philips
SAA 7111A video input processor. TV-out uses Analog Device
725AR. Video-in provides an 8-pin header connector for S-video.
Alternatively, an optional cable kit provides an RCA yellow jack
for composite video input (see Appendix E). Video-out provides a
6-pin header connector for S-video. Alternatively, an optional
cable kit provides an RCA yellow jack for composite video output
(see Appendix E).
6.2 Installation of video driver
Before installing the Video-in driver, please take note of the
procedures detailed below. You must know which operating
system you are using in your PCM-5864/E/L, and then refer to the
corresponding installation flow chart. Just follow the steps in the
flow chart. You can quickly and successfully complete the
installation, even if you are not familiar with instructions for
Windows.
Note:
72
PCM-5864/E/L User's Manual
The CD-ROM drive is designated as "D" through-
out this chapter.