Dmx Control Without Id Addressing; Dmx Control With Id Addressing - Chauvet COLORado 1 IP User Manual

DMX Control
Without ID
Addressing
DMX Control With
ID Addressing
COLORado™ 1 IP User Manual Rev. 2
In this mode, each product will respond to a unique starting address from the DMX
controller. All products with the same starting address will respond in unison.
Select the TOUR personality as shown in
1. Set the running mode:
a. Go to the RUN main level.
b. Select the DMX programming level.
2. Set the starting address:
a. Go to DMX.
b. Select the starting address (001~512).
3. Deactivate ID Addressing on each product:
a. Go to SET > Id.
b. Select OFF.
Make sure to deactivate ID Addressing in each product when using the TOUR
personality. Otherwise, unintended results may occur if channel 11 is not set to "0."
The highest recommended starting address for each DMX mode are as follows:
DMX Mode DMX Address
TOUR 502
ARC.1 510
AR1.d 509
In this mode, the products with the same DMX starting address will respond to the DMX
controller based on the product's individual ID address setting. If you select ID address
"0," all the products with the same DMX address will respond in unison. Otherwise, each
product will follow the control for its particular ID address.
1. Repeat steps 1, 2, and 3 from DMX Control Without ID Addressing.
2. Activate ID Addressing in each product:
a. Go to SET > Id.
b. Select ON.
DMX Personality.
DMX Mode DMX Address
ARC.2 509
AR2.D 508
AR2.S 507
Operation
DMX Mode DMX Address
HSV 510
-9-