Electrical Wiring Diagram; Service Instructions; Replacing The Light Bulb; Screen Cleaning - Hearth and Home Technologies Simplifyre SFE-35 Homeowner's Installation & Operating Manual

WARNING
Disconnect power at circuit breaker before attempting any
maintenance or cleaning to reduce the risk of fire, electrical
shock or personal injury.

REPLACING THE LIGHT BULB

This appliance uses a single 12 Volt, 35 Watt, MR-16 bulb.
The bulb is located behind the smoke shield.
A spare is provided with the unit. Replacement bulbs (Part
No. 4050-123) are available through your Simplifyre dealer.
•
Turn off power to the unit at the main service panel.
•
Let the fireplace cool if it has been operating.
•
Release the spring pins and remove the upper shield.
•
Remove the two screws on the projector basket.
•
Rotate the housing down to access the bulb.
•
Remove the screws holding the bulb and socket.
•
Unplug the bulb from the socket.
•
Replace the bulb.
•
Re-assemble in the reverse order.
4050-261 Rev A 8-10-2007

SERVICE INSTRUCTIONS

SCREEN CLEANING

MAINTENANCE OF MOTORS

The motors used on the fan and flame projector assembly
are pre-lubricated for extended bearing life and require no
further lubrication. However, periodic cleaning/vacuuming of
the fan/heater unit is recommended.
7
During shipment, installation, handling, etc., the
screen surface may collect dust particles; these can
be removed by lightly wiping with a clean, dry cloth.