Hearth and Home Technologies 350TRSI-AUF Owner's Manual

Heat & glo dvp and slp venting systems
Hide thumbs Also See for 350TRSI-AUF:

Advertisement

Quick Links

Models:
350TRSI-AUF
350TRSILP-AUF
• Important operating
a n d m a i n t e n a n c e
instructions included.
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.
• DO NOT USE OR STORE FLAMMABLE
MATERIALS NEAR THIS APPLIANCE.
• DO NOT SPRAY AEROSOLS IN THE VICIN-
ITY OF THIS APPLIANCE WHILE IT IS IN
OPERATION.
• What to do if you smell gas
- DO NOT try to light any appliance.
- DO NOT touch any electrical switch. DO
NOT use any phone in your building.
- Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
- If you cannot reach your gas supplier, call
the fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
NOTICE
DO NOT DISCARD THIS MANUAL
• Read, understand and follow
these instructions for safe
installation and operation.
Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10
Owner's Manual
Installation and Operation
• Leave this manual with
party responsible for use
and operation.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• DO NOT touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• DO NOT PLACE ARTICLES ON OR AGAINST THIS
APPLIANCE.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
This is a room sealed appliance and no other ventilation is
required than what is provided.
SAI Global
Ref No GSCS20162
AS4553:2008
1

Advertisement

Table of Contents
loading

Summary of Contents for Hearth and Home Technologies 350TRSI-AUF

  • Page 1 • Installation and service must be performed This is a room sealed appliance and no other ventilation is by a qualifi ed installer, service agency, or the required than what is provided. gas supplier. Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 2: Vent Information And Diagrams

    • When penetrating a combustible ceiling, a ceiling fi restop must be installed. • Horizontal runs of vent do not require vertical rise; Horizontal horizontal runs may be level. Figure 7.1 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 3: Top Vent - Horizontal Termination

    SLP pipe 7 ft. min. vertical = 11 ft. max. horizontal Note: A 152 mm section of straight fl ue must be attached to the heater before a 90° elbow. USE SLP SERIES COMPONENTS ONLY Figure 7.4 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 4: Two Elbows

    10 ft. 3.05 m 30 ft. 9.14 m 10 ft. 3.05 m = 30 ft. (9.14 m) Maximum = 10 ft. (3.05 m) Maximum INSTALLED HORIZONTALLY Figure 7.5 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 5 3.66 m = 6 ft. (1.83 m) Maximum *H = 12 ft. (3.66 m) Maximum = 32 ft. (9.75 m) Maximum = 36 ft. (10.97 m) Maximum Figure 7.6 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 6: Top Vent - Vertical Termination

    1 inch clearance to combustible materials all around the 8 inch pipe. For alternative installations, other than depicted, contact your dealer for further information. Figure 7.7 RESTRICTOR PLATE Figure 7.8 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 7: Flue System Approvals And Installations

    PIPE LENGTH WALL FIRESTOP 90 DEGREE ELBOW CEILING WALL BRACKET FIRESTOP Flue system termination kits DVP-SERIES SLP SERIES DVP-TVHW DVP-TRAP2 DVP-FBHT SLP-TRAP2 SLP-TVHW Figure 7.9 Flue Components and Terminations Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 8 1.52 m 16 ft. 4.88 m = 36 ft. (10.97 m) Maximum *No specifi c restrictions on this value EXCEPT cannot exceed 32 ft. (9.75 m) Figure 7.10 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 9: Three Elbows

    Note: A 152 mm section of straight fl ue must be attached to the heater before a 90° elbow. USE SLP SERIES COMPONENTS ONLY INSTALLED HORIZONTALLY Figure 7.11 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 10 USE DVP SERIES COMPONENTS ONLY Figure 7.12 One 45º Elbow Do not use a 45º elbow in corner installations. Use two 90º elbows instead. USE DVP SERIES COMPONENTS ONLY Figure 7.13 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 11 1.83 m 10 ft. 3.05 m INSTALLED HORIZONTALLY = 30 ft. (9.14 m) Maximum = 4 ft. (1.22 m) Maximum = 10 ft. (3.05 m) Maximum Figure 7.15 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 12: One Elbow

    4 ft. 1.22 m 10 ft. 3.05 m = 32 ft. (9.75 m) Maximum = 9 ft. (2.74 m) Maximum USE DVP SERIES COMPONENTS ONLY INSTALLED HORIZONTALLY Figure 7.17 Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 13 *No specifi c restrictions on this value EXCEPT cannot exceed 32 ft. (9.75 m) Maximum Î = 8 ft. (2.44 m) Maximum USE DVP SERIES COMPONENTS ONLY INSTALLED Figure 7.18 HORIZONTALLY Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 14: Vent Clearances And Framing

    * Shows center of vent framing hole for top or rear venting. The center of the hole is one 25.4 mm above the center of the horizontal vent pipe. Figure 8.2 Wall Penetration Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 15: Install The Ceiling Firestop

    INSTALL ATTIC INSULATION SHIELDS BEFORE OR AFTER INSTALLATION OF VENT SYSTEM 3 FASTENERS PER SIDE CEILING FIRESTOP CEILING FIRESTOP INSTALLED BELOW CEILING INSTALLED ABOVE CEILING Figure 8.4 Installing the Attic Shield Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...
  • Page 16: Install Attic Insulation Shield

    These tabs must be used to prevent blown insulation from getting between the shield and vent pipe, and to Figure 8.6 Heat Zone Knockout maintain air space clearance. Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. B • 8/10...

This manual is also suitable for:

350trsilp-auf

Table of Contents