Hearth and Home Technologies CFL-18NG-C Owner's Manual
  1. Manuals
  2. Brands
  3. Hearth and Home Technologies Manuals
  4. Indoor Fireplace
  5. CFL-18NG-C
  6. Owner's manual

Hearth and Home Technologies CFL-18NG-C Owner's Manual

Natural gas propane installation and operation
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
MODELS:
NATURAL GAS
CFL-18NG-C
CFL-24NG-C
CFL-30NG-C
ST-CFL-24NG-B
CFL-24NG-IPI
• Important operating
a n d m a i n t e n a n c e
instructions included.
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.
• Do not store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• What to do if you smell gas
- Do not try to light any appliance.
- Do not touch any electrical switch. Do not
use any phone in your building.
- Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppli-
er's instructions.
- If you cannot reach your gas supplier, call
the fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
In the Commonwealth of Massachusetts:
• Installation must be performed by a licensed plumber
or gas fi tter.
• The chimney fl ue damper, when used with gas logs,
will be welded open or completely removed.
• A CO detector shall be installed in the room where the
appliance is installed.
Hearth & Home Technologies • CFL-18/24/30-C, CFL-24-IPI, ST-CFL-24-B • 526-910 Rev. L • 11/14
PROPANE
CFL-18LP-C
CFL-24LP-C
CFL-30LP-C
ST-CFL-24LP-B
CFL-24LP-IPI
CAUTION
DO NOT DISCARD THIS MANUAL
• Read, understand and follow
these instructions for safe
installation and operation.
Owner's Manual
Installation and Operation
• Leave this manual with
party responsible for use
and operation.
WARNING
HOT SURFACES!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CFL-18NG-C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Hearth and Home Technologies CFL-18NG-C

Summary of Contents for Hearth and Home Technologies CFL-18NG-C

  • Page 1 Owner’s Manual Installation and Operation MODELS: NATURAL GAS PROPANE CFL-18NG-C CFL-18LP-C CFL-24NG-C CFL-24LP-C CFL-30NG-C CFL-30LP-C ST-CFL-24NG-B ST-CFL-24LP-B CFL-24NG-IPI CFL-24LP-IPI CAUTION DO NOT DISCARD THIS MANUAL • Important operating • Read, understand and follow • Leave this manual with a n d m a i n t e n a n c e...

  • Page 2: Gas Information

    Read this manual before installing or operating this appliance. Please retain this owner’s manual for future reference. Congratulations Congratulations on selecting a Hearth & Home Technologies This owner’s manual should be retained for future reference. We suggest that you keep it with your other gas fi...

  • Page 3: Table Of Contents

    Table of Contents 1 Introduction A. Appliance Certifi cation ......4 B. BTU Specifi cations ....... 6 C.

  • Page 4: Introduction

    Introduction A. Appliance Certifi cation This log set is to be installed only in a solid-fuel burning fi replace with a working fl ue and one constructed of non- combustible material. The minimum permanent vent open- MODELS: CFL-18NG/LP-C, CFL-24NG/LP-C, CFL- ing provided by the fi...
  • Page 5 MINIMUM FIREPLACE SIZE FRONT WIDTH : 23 ” (750mm) REAR WIDTH : 19 ” (521mm) TOP VIEW DEPTH : 13 ” (331mm) HEIGHT : 22” (508mm) MODEL CFL-18-C MINIMUM FIREPLACE SIZE FRONT WIDTH : 27 ” (750mm) REAR WIDTH : 22” (521mm) DEPTH : 15 ”...

  • Page 6: Btu Specifi Cations

    Orifi ce Input BTU/h Size (DMS) (U.S. or Canada) or authorities having jurisdiction. When installing above 2000 feet elevation: CFL-18NG-C 60,000 7-1.55 mm • In the USA: Reduce input rate 4% for each 1000 feet (0-2000 FT) CFL-24NG-C above 2000 feet.

  • Page 7: Getting Started

    Getting Started B. Installation CAUTION! When installing this log set in a factory built fi replace, be certain to consult the fi replace installation 1. GAS CONNECTION manual. ALL knockouts in the fi replace through which the a. Run proper size gas line into fi replace. A 1/2 inch (13mm) gas supply line is run MUST be resealed with insulation gas line, with a 3/8 inch (10mm) reduction for hook-up, is after the gas line is in place.
  • Page 8 e. A damper stop clamp with set screw is provided to pre- 2. ELECTRICAL INSTALLATION vent full closure of the fi replace damper blade. Attach • This appliance may be used with a wall switch and/or the clamp to the edge of the damper blade with pliers remote control.
  • Page 9 3. AIR SHUTTER SETTINGS. This appliance has an adjustable air shutter (which con- trols the primary air) factory set for the minimum vertical vent run. If your installation has more than the minimum required vertical vent length, adjustment of the air shutter may be necessary to obtain optimal fl...

  • Page 10: Operating Guidelines And Maintenance Instructions

    Operating Guidelines and Maintenance Instructions A. Before Lighting Appliance WARNING Before lighting this appliance determine if it has a Standing Pilot or IntelliFire ignition system by viewing the wiring HOT SURFACES! system and gas valve. If this appliance has a red or black Glass and other surfaces are hot during operation AND cool down.

  • Page 11: For Your Safety

    Lighting Instructions (IPI) The IPI system must be operated with two D-cell batteries. FOR YOUR SAFETY LIGHTING READ BEFORE LIGHTING INSTRUCTIONS (IPI) WARNING: If you do not follow these instructions exactly, a fi re or explosion 1. This appliance is equipped with an ignition may result causing property damage, personal injury or loss of life.
  • Page 12 Lighting Instructions (Standing Pilot) LIGHTING FOR YOUR SAFETY INSTRUCTIONS READ BEFORE LIGHTING 1. Turn off all electric power to the appliance. WARNING: If you do not follow these instructions 2. Push in gas control knob exactly, a fi re or explosion may result causing property slightly and turn clockwise damage, personal injury or loss of life.

  • Page 13: Troubleshooting

    Troubleshooting With proper installation, operation, and maintenance your gas appliance will provide years of trouble-free service. If you do experience a problem, this troubleshooting guide will assist a qualifi ed service technician in the diagnosis of a problem and the corrective action to be taken. This troubleshooting guide can only be used by a qualifi ed service technician. Contact your dealer to arrange a service call by a qualifi...
  • Page 14 Troubleshooting (continued) Symptom Possible Cause Corrective Action 3. (Continued) c. Valve. Turn the valve knob to the ON position. Place the ON/OFF switch in the ON position. Check the millivolt meter a the thermopile terminals. The millivolt meter should read greater than 125mV. If the reading is ac- ceptable, and if the burner does not come on, replace the gas valve.

  • Page 15: Intellifire Ignition System

    B. IntelliFire Ignition System Symptom Possible Cause Corrective Action 1. Pilot won’t light. a. Incorrect wiring. Verify “S” wire (white) for sensor and “I” wire (orange) for ignitor The ignitor/module are connected to correct terminals on module and pilot assembly. makes noise, but no b.
  • Page 16 IntelliFire Ignition System - (continued) Symptom Possible Cause Corrective Action a. A shorted or loose connection in fl ame Verify all connections to wiring diagram in manual. Verify 4. Pilot lights but contin- sensing rod. connections underneath pilot assembly are tight. Verify ues to spark, and main connections are not grounding out to metal chassis, pilot burner will not ignite.

  • Page 17: Reference Materials

    IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 18 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 19 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 20 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 21 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.
  • Page 22 IMPORTANT: THIS IS DATED INFORMATION . Parts must be ordered from a dealer or Stocked Hearth and Home Technologies does not sell directly to consumers distributor. . Provide model number and serial number when requesting service parts from your dealer or distributor.

  • Page 23: Limited Lifetime Warranty

    B. Limited Lifetime Warranty Hearth & Home Technologies LIMITED LIFETIME WARRANTY Hearth & Home Technologies, on behalf of its hearth brands (”HHT”), extends the following warranty for HHT gas, wood, pellet, coal and electric hearth appliances that are purchased from an HHT authorized dealer. WARRANTY COVERAGE: HHT warrants to the original owner of the HHT appliance at the site of installation, and to any transferee taking ownership of the appliance at the site of installation within two years following the date of original purchase, that the HHT appliance...
  • Page 24 B. Limited Lifetime Warranty (continued) WARRANTY CONDITIONS: • This warranty only covers HHT appliances that are purchased through an HHT authorized dealer or distributor. A list of HHT authorized dealers is available on the HHT branded websites. • This warranty is only valid while the HHT appliance remains at the site of original installation. •...

  • Page 25: Contact Information

    C. Contact Information Hearth & Home Technologies 7571 215th Street West, Lakeville, MN 55044 www.hearthnhome.com Please contact your Hearth & Home Technologies dealer with any questions or concerns. For the location of your nearest Hearth & Home Technologies dealer, please visit www.hearthnhome.com. - NOTES - ________________________________________________________________________________ ________________________________________________________________________________...

This manual is also suitable for:

Cfl-18lp-cCfl-24ng-cCfl-24lp-cCfl-30ng-cCfl-30lp-cSt-cfl-24ng-b ... Show all

Table of Contents