Unpacking And Inspection - HearthStone STERLING “G” 8531 Owner's Manual

HearthStone Quality Home Heating Products
V
ENTILATION
The Sterling requires a free flow of air to provide
ventilation around the unit. Your Sterling Direct-Vent
gets its combustion air through the venting system, and
will function well in extremely air-tight structures as
well as less air-tight structures.
C
Any shield, door, safety screen or component removed
for servicing the Sterling must be replaced prior to
operating the unit. If you believe that your Sterling is
not performing properly in any way whatsoever,
immediately discontinue operation until the unit has
been inspected and approved for continued operation
by qualified service personnel.
U
NPACKING AND
P L
ACKING IST
1 - Sterling Gas Fireplace Heater
3 - Decorative Ceramic Fiber Log set
1 - Bag of Charcoal Embers
1 - Ember Screen
1 - Owner's Manual
1 - Warranty Card
1 - Thermostat with 40' Thermostat Wire
I D
NSPECT FOR AMAGE
Do not install or put into service a damaged or incomplete heater.
Prior to removing the shipping carton, inspect the carton for visible signs of damage. Carefully remove the shipping
carton. We carefully package the Sterling to withstand shipment without
damage. However, damage can occur during transit and handling, so take care
to inspect for damage when unpacking and installing the unit.
The unit should appear square and true. The stones should be whole and
without cracks, chips or breakage. The sheet metal parts should be smooth and
free of bends or dents. The enameled cast iron (if enameled) should be free of
chips or cracks. If visible or concealed damage is found or suspected, contact
your dealer for instructions.
The three top stones are not cemented or otherwise permanently fastened in
place.
Carefully remove and set aside the three top stones. Use the protective
wrapping material to temporarily protect the stones from chipping and damage
A U
ROUND NIT
AUTION
I
NSPECTION
Note
MODEL Sterling "G" Direct-Vent
This unit is equipped with a delayed ignition safety
switch. In the case of a delayed ignition, this switch
may only be reset by a qualified service technician
after careful inspection of all seals and gaskets.
Do not clean glass when hot.
Do not operate this stove with glass removed, cracked
or broken. Do not substitute materials. Replacement
of glass should be done by a licensed or qualified
service person.
REAR LOG
FRONT LOG
EMBERS
EMBER SCREEN
6
W
ARNING
W
ARNING
W
ARNING