Setting The Keypad Lighting - GE NetworX NX-1500E User Manual

Time Hour Code
12:00
Midnight
1:00 AM
2:00 AM
3:00 AM
4:00 AM
5:00 AM
6:00 AM
7:00 AM

SETTING THE KEYPAD LIGHTING

Step 1 Press [r]-[9]-[1]. The service light will flash.
Step 2 Press the [1] key to lighten, or press the [2] key to darken the
illumination behind the buttons.
adjustment in a darkened room.
The service light will be "on" if the security system requires service. If the
service light is "on", press the [r] key followed by the [2] key to determine
the service condition.
what service(s) is required. Call your service provider immediately for these
problems. Below is a listing of what each light means in a service condition.
TO EXIT THE SERVICE LIGHT MODE - PRESS THE [#] KEY.
LIGHT
1 SYSTEM FAULT - Press the [1] key. The zone light(s) that is
illuminated corresponds to the system fault(s) below:
1 Over Current Fault
2 Siren Trouble
3 Box Tamper
4 Expander Power
Note: Faults 1 & 2 are global in nature and will affect all
partitions of a multi-partition system. Press the [#] key to
return to the 1 of 8 service lights.
2 ZONE TAMPER - Press the [2] key and the zone light(s) will
illuminate showing the zone(s) that are tampered. Press the [#]
key to return to the 1 of 8 service lights.
Time
00 8:00 AM
01 9:00 AM
02 10:00 AM
03 11:00 AM
12:00
04
Noon
05 1:00 PM
06 2:00 PM
07 3:00 PM
SERVICE MENU
One or more zone lights will illuminate indicating
Hour Code
08
09
10
11
12
13
14
15
It is usually easier to set this
PROBLEM
5 Expander Low Battery
6 Expander Box Tamper
7 Expander Trouble
8 Ground Fault
Page 17
Time Hour Code
4:00 PM 16
5:00 PM 17
6:00 PM 18
7:00 PM 19
8:00 PM 20
9:00 PM 21
10:00 PM 22
11:00 PM 23