Quick Shadow Tour 1 Programming Short Cut - GE KTD-405 User Manual

Controller keypad
Hide thumbs Also See for KTD-405:
Table of Contents

Advertisement

Quick Shadow Tour 1 programming short cut

This section explains how to use the shadow tour 1 programming shortcut.
To program a ShadowTour™, do the following:
1. Beginning at the normal operating display,
bring up the PROGRAM SHADOW TOUR
display (Figure 52) by pressing and holding
the esc key, then pressing the tour key.
2. At the PROGRAM SHADOW TOUR display
(Figure 53), press the + side of the zoom,
focus, or iris key to start recording a shadow
tour.
3. Quickly move to the next step after the
keypad beeps and the END SHADOW TOUR
PROGRAMMING display appears
(Figure 54).
4. Begin the manual operation sequence you want to record as your ShadowTour.
5. At the END SHADOW TOUR PROGRAMMING display, press the esc key to stop recording the
shadow tour.
Note: The keypad is still recording your manual operation even though the END SHADOW TOUR PROGRAMMING display
returns to the normal operating display after a few seconds. Continue your sequence and press esc to stop recording
Your shadow tour is now available for use. Follow the keypad's instructions for activating the shadow tour. See
Table 3 on page 38.
Note: The zoom, focus, and iris buttons do not work while programming a shadow tour using the short cut method. 405-2D
users should not use this feature because the Zoom keys are disabled.
Figure 52. Normal operating display
CAMERA 0
MONITOR 1
Figure 53. PROGRAM SHADOW TOUR display
PROGRAM SHADOW
TOUR? _
Figure 54. END SHADOW TOUR PROGRAMMING display
PRESS <ESC> TO END
SHADOW TOUR
Chapter 3
35
Programming

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ktd-405-2dKtd-405a

Table of Contents