Table of Contents
Advertisement
4.
When all the keys are not pressed at all for a certain time (O1-02), the display goes to idle
mode. Once any key is pressed, the display will return to the LCD monitor selection value set
in constant O1-01.
5.
When all the keys are not pressed at all for a certain time (O2-09) the LCD Display and all the
LED indicators, except the RUN/STOP indicator, will be switched off. The display idle function
can save power.
6.
Press
key to increase the setting value and
and
keys at the same time to enable the cursor to move to the left digit from the current
digit. For example, if the current digit stays in decimal, press
the digit to move to centesimal.
LED Indicators
LED
Name
1
AC IN
2
AC CHARGER
3
SOLAR PANEL
4
SOLAR CHARGER Solar charger is working
5
AC OUT
6
INVERTER
7
BATTERY
8
ATS
9
RUN/STOP
10
COM./ERR.
Battery charger / inverter COMBI-GAMMA
L ED ON
1.
Input voltage normal, and position
> "transfer Voltage Level" (150VAC~240VAC)
2.
Input voltage frequency range in
between(45~65Hz)
Green: Battery charger is working.
Solar module is delivering energy.
There is voltage at the "AC OUT" terminal.
Green: Inverter is working.
FLOAT or ABSOR. Or BULK charge
state of battery.
Green: ATS switch is active AC IN voltage is be-
ing sent directly to AC OUT terminal
Green: Combi-Gamma turn on.
Red: Combi-Gamma turn off.
NOTE: Green Blink: Auto-Restart is in use
Remote control port in communication/in error
key to decrease the setting value. Press
and
No input power
-------------------------------------------------
1.
Solar module isn't connected
or it is Night / (cloudy day)
No external solar
charger is connected.
-------------------------------------------------
-------------------------------------------------
-------------------------------------------------
-------------------------------------------------
-------------------------------------------------
at the same time for
LED OFF
090138.02
23
Advertisement
Table of Contents
