Table of Contents
Advertisement
3.1 Upper-Front Panel Display
7
2
1
3
4
Push Buttons
Push buttons
PB1
RUN/STOP
PB2
MODE 1
PB3
MODE 2
PB4
MODE 3
PB5
MODE 4
PB6
DSPL
PB7
ENTER
PB8
UP (
PB9
DOWN (
Note:
1.
When pressing RUN/STOP key, the holding time to remain on the key has to be at least 2 seconds
(initial setting) to activate the RUN or STOP function in order to avoid any accidental pressing on
the RUN/STOP key. The second time can be adjusted in RUN/STOP KeyHoldTime (O2-07).
2.
When changing any of four modes to another mode, Combi-Gamma has to STOP and then
press the desired mode key (MODE 1, MODE 2, MODE 3 or MODE 4). Press and hold the
mode key for at least 5 seconds (initial setting) to activate the mode change this in order to
avoid a change of mode by accidental pressing on of the mode keys. The setting of the hold
time can be adjusted in MODE Key Hold Time (O2-06).
3.
The beep sound, when pressing a key, can be enabled or disabled in
(O2-01)
22
090138.02
Chapter 3 Display and wiring
PB8
PB9
PB7
Name
Combi-Gamma RUN/STOP key
AC Power as Priority Support
INVERTER as Priority Support
Green Power as Priority Support
AC Power Charge
Multi-display select key
Data write-in key
)
Increment key
)
Decrement key
PB6
PB2
PB3
PB4
PB5
PB1
Description
Before changing from one mode to
another, it has to stop running and be in
STOP mode
Press
to enable the cursor to move to the left
digit from the current digit.
8
6
5
10
9
and
keys at the same time
Key Pressed Beep Sel
Battery charger / inverter COMBI-GAMMA
Advertisement
Table of Contents
