Table of Contents
Advertisement
Figure 36-a: Use the Cursor for a Voltage Measurement
When the MENU button is pressed, the data table appears as shown in Figure 36-b:
To use the cursor for a Time measurement on CH1, perform the following steps:
1.
Press the MENU key; the function menus will appear at the right of the
screen.
2.
Press the MENU ▲ or MENU ▼ key to select Cursor measurement. Two (2)
selectable options will then appear at the bottom of the screen.
3.
Press the F1 key to select the measurement type Time. Two vertical dashed
lines T1 and T2 will appear on the screen.
4.
Press the F2 key and select the channel CH1.
Figure 36-b: Data Table
61
V5.1 ‐ March 2010
Advertisement
Table of Contents
