Table of Contents
Advertisement
R
F
ECALL THE
ACTORY
To reset the Oscilloscope to the factory default settings, refer to the following:
1. Press the MENU key; the function menu will appear on the right side of the
screen
2. Press the MENU ▲ or MENU ▼ key to select a FUNCTION; three options will be
visible at the bottom of the screen.
3. Press F1 (Recall Factory) to recall the factory settings.
4. Press F2 to select "Auto calibration".
specified operating temperature by more than 5 degrees Celsius, an Auto
Calibration should be performed.
Refer to Figure 10:
O
I
SCILLOSCOPE
NPUT
The Oscilloscope has two (2) signal inputs (located on the lower right side) for CH1
and CH2 measurements.
Isolated inputs allow for independent floating measurements between Multimeter and
Scope functions.
D
S
EFAULT
ETTINGS
f the ambient temperature varies from the
I
Figure 10: Resetting the Oscilloscope
C
ONNECTIONS
19
V5.1 ‐ March 2010
Advertisement
Table of Contents
