Table of Contents
Advertisement
2.
Use the MENU ▲ or MENU ▼ key to select Wave Save. Four (4) selectable
options will then appear at the bottom of the screen.
3.
Press the F1 key to select CH1 as the signal source.
4.
Press the F2 key to select Address A.
5.
Press the F3 key to save the waveform on CH1 in address A.
To display the saved waveform on the screen, perform the following steps:
6.
Press F4 to select Start for Address A. The waveform saved in Address A will be
displayed in green. The zero point, voltage the time will display in purple
50
V5.1 ‐ March 2010
Advertisement
Table of Contents
