Introduction; Safety Instructions; Maintenance Guidelines - Intelix 8002MCB-XLR User Manual

MC Series

1.0 Introduction

This manual describes the components and operation of the Intelix MC Series line of mic/line
mixers. As with all Intelix products, the MC Series ensures the highest quality audio signal
production and control through easy-to-use features.
Intelix offers three models of MC Series mic/line mixers to choose from: the 8002MCB-FP with
XLR connectors and all trim and pad controls on the front panel; the 8002MCB-PHNX with
Phoenix connectors; and the 8002MCB-XLR with XLR connectors.
All three models offer studio quality compression/limiting and feature recessed selector switches
for the bussing of input signals to the main, AUX, or both outputs.

1.1 Safety Instructions

Read all directions carefully before use.
The VC Series system includes a variety of electrical equipment; all precautions usually taken
with electrical equipment must be abided by. Specifically:
- Grounding: verify both the VC Series mixer and the devices connected to it are
properly grounded.
- Power Supply: use only the power supply provided by the manufacturer or one that
meets the manufacturer's specifications.
- Cords and Cables: route all cords and cables so that they will not be trip hazards or
subject to damage (from being run over or pinched) which could cause them to be-
come shock hazards. Pay particular attention to cords at plugs, convenience recep-
tacles, and the point where they enter the mixer.
- Fire: if the mixer or other electrical equipment catches fire, extinguish the fire using
a carbon dioxide (CO
Never use a water extinguisher.

1.2 Maintenance Guidelines

Electronic devices operate best in clean, well-ventilated environments. The MC Series mixer
contains many electronic components in a compact arrangement, thereby generating more heat
than the average electronic device. It should be located where it will be well-ventilated and far
from other heat-generating equipment, such as amplifiers.
The main ventilation ports are in the sides of the chassis. To operate properly, they must be kept
clear of other components (cables, etc.). When several MC Series mixers are located together,
the amount of heat generated may be difficult to dissipate if the units are stacked directly on each
other.
Ensure adequate ventilation is provided on the sides, ambient air temperature does not exceed
72 degrees F, and an open rack space is left above and below the units.
To minimize hum in the system, avoid placing cables near EMF-producing devices such as elec-
trical motors, fluorescent lights, AC power lines, and SCR dimmers.
4
Feature Chart
) extinguisher or any extinguisher rated for electrical fires.
2
www.intelix.com
Intelix LLC
2222 Pleasant View Road
Middleton, WI 53562
User Manual User Manual User Manual
User Manual User Manual
Phone: 608-831-0880
Toll-Free: 1-866-4-MATMIX
Fax: 608-831-1833