Intelix 8002MCB-XLR User Manual page 14

MC Series
This dynamics controller allows for compres-
sion and limiting functions by providing a
threshold and ratio controls.
The threshold control sets what signal level
will activate the compressor/limiter. It has a
range of -40 to +20dBu. The factory setting
for the threshold is 0 VU (+4 dBu); however,
it may be adjusted from -40 dBu to +20 dBu and is adusted with a screw-potentiometer
located on the front of the chassis.
The ratio control sets the compression ratio that will be applied when the signal exceeds the
threshold. It has a range from 0% to 100%. Limiting is engaged when the compression ration
is 10:1 or greater. The factory setting for the compression ratio is 100% (at this maximum
setting, the circuit performs the limiter function); however, it may be adjusted through a
screw-potentiometer located on the front of the chassis.
Note: The Bar Graph Output Meter is used to view the effects of adjusting the Compressor/
Limiter controls. Ensure the amplifiers are off while making adjustments. If the amplifier/
speaker combination being used is such that the speaker(s) can be overdriven to failure,
always operate the mixer with the Output Limit Switch in the "on" position and the ratio
should be set at 100%.
3.7.4 .1 How the compressor/limiter works
Two variables control the operation of the Compressor/Limiter: Ratio and Threshold.
The ratio setting determines the ratio of input to output and can vary from 1 to infinity. Set at
1 the compressor has no effect on the signal; a 1 dB change on the input causes a 1 dB change
on the output. Set at infinity, there is a
"brick ceiling" at the threshold, since a
change on the input causes no change at
all on the output. The factory setting for
the ratio is infinity.
The threshold setting determines the
input level at which the compressor/
limiter takes effect. The threshold is
variable from -40dBu to +20 dBu.
Below the threshold, the compressor/
limiter has no effect on audio. Above
threshold the compressor limiter com-
presses the audio at the rate determined
by the ratio setting. The factory setting
for the threshold is +4 dBu.
14
User Manual User Manual
User Manual User Manual User Manual
www.intelix.com
Intelix LLC
2222 Pleasant View Road
Middleton, WI 53562
Phone: 608-831-0880
Toll-Free: 1-866-4-MATMIX
Fax: 608-831-1833