Bus Routing Options; Linking - Intelix 8002MCB-XLR User Manual

MC Series
3.8.2.2 Jumpers J22-J23
The LED Bar Graph Output Meter may be set to register either the main or auxiliary bus
output audio signal. The choices are:
- J22 installed: The Bar Graph meters the main bus output. This is the factory default.
- J23 installed: The Bar Graph meters the auxiliary bus output.
Note: The meter will operate only when a jumper is in one of these two positions.
3.8.2.3 Jumpers J20-J21
The LED Bar Graph Output Meter may be set to register either the peak or average level
of the output audio signal. The choices are:
- J20 installed: The Bar Graph meter registers the peak level of the audio output.
- J21 installed: The Bar Graph registers the average level of the audio output. This is
the factory default.
Note: The Bar Graph meter will operate only when a jumper is in one of these two positions.

3.8.3 Bus Routing Options

3.8.3.1 Aux in jumpers J17 and J18
These jumpers determine the destination of the Auxiliary Input. The choices are:
- J17 installed: Auxiliary Input is routed to Main Output
- J18 installed: Auxiliary Input is routed to Auxiliary Output.
- J17 and J18 both installed: Auxiliary Input is routed to both Main and Aux outputs.
This is thefactory default setting.
3.8.3.2 Aux source jumpers J1 and J2
These jumpers determine which of two gain controls are used to control the level of the Aux
output. The choices are:
- J1 installed: Aux output gain is controlled by the internal pot, "Aux pregain pot"
RP23 (see page 19 for location). The front panel Aux output volume knob continues
to independently control the gain of the headphone amplifier jack on the front panel.
This setting is typically used in a linking situation where the output from a mixer
must remain fixed, since J1 makes the output of that mixer tamper proof (from the
front panel). With J1 installed, the front panel volume knob controls only the head
phone level.
- J2 installed: Aux output gain is controlled by Aux volume knob on front panel. 1/4
inch Headphone amp also controlled by the Aux volume knob, but not independently
of the Aux output.
Note: Never install jumpers in both positions J1 and J2.
16
www.intelix.com
Intelix LLC
2222 Pleasant View Road
Middleton, WI 53562
User Manual User Manual
User Manual User Manual User Manual
Phone: 608-831-0880
Toll-Free: 1-866-4-MATMIX
Fax: 608-831-1833