Avermedia AVerDiGi EB1304NET SATA+ User Manual page 31

OSD MENU
SENSOR SETUP
SENSOR REC TIME 010 SEC
ALARM OUT TIME 010 SEC
CHANNEL - 1 NOT INSTALLED
CHANNEL - 2 NOT INSTALLED
CHANNEL - 3 NOT INSTALLED
CHANNEL - 4 NOT INSTALLED
VIDEO LOSS ALARM
1
MOTION SETUP
MOTION CAMERA 1
SENSITIVITIY
MEDIUM
010 SEC
MOTION RECORD TIME
NETWORK SETUP
STATIC
IP MODE
NW ENABLE 1
VIDEO PORT 0080
UPGARDE PORT 5005
Description
SENSOR REC TIME
Set the amount of time (in second) to start record when the
sensor has triggered
ALARM OUT TIME
2 3 4
Set the amount of time (in second) to continue sending the
alarm once triggered
CHANNEL 1~4
Customize the initial state of the attached sensor. Refer to the
table below to customize the sensor state
Condition
NOT INSTALLED
NORMAL OPEN
NORMAL CLOSE
VIDEO LOSS ALARM
Select the channel when the video loss that the DVR system will send
out a alarm
MOTION CAMERA
2 3 4
Enable/disable the channel number to detect motion.
SENSITIVITY
Set the sensitivity level. The sensitivity is from H (High), 9~ 2
and L (Low).
MOTION RECORD TIME
Set the amount of time (in second) to record when motion is
detected.
NETWORK SETUP
Setup the network parameters for the internet or intranet remote
2 3 4
monitor or playback.
IP MODE
The system provides 3 types of IP setup mode – Static, DHCP,
and PPPOE.
Use
▲
MODE, and then press
change the selections and press
selection.
STATIC: Assigns a constant IP address for the DVR
system. Use
and select items, and then press
selection. Use
select or enter the configuration value.
- IP ADDRESS: Assign a constant IP address which a real
IP addresses give from ISP to DVR system.
Description
Indicates that there is no sensor connected
Indicates that the initial state of the sensor is
normal open. Video recording initiates when
there is a changes in the sensor state
Indicates that the initial state of the sensor is
normal close. Video recording initiates when
there is a changes in the sensor state
and buttons to go up and down and select IP
▼
. Use
and
▲
▼
and
26
and buttons to
▲
▼
or to make a
buttons to go up and down
or to make
to move left and right to