Accessing Charger Information; Reading Remote Panel And Onboard Display Leds; Reporting While Charging Or Equalizing - Xantrex TC1012 Owner's Manual

There is only ONE way to safely turn the Truecharge™ 2
Battery Charger off (Disable):
◆ Disconnect the AC power at the source and disconnect all
This is the only state where the Truecharge™ 2 Battery
Charger is completely de-energized.
When the Truecharge™ 2 Battery Charger is disabled, the
optional remote panel is inactive.

Accessing Charger Information

The Truecharge™ 2 Battery Charger provides a lot of
information about the status of the charger and the batteries.

Reading Remote Panel and Onboard Display LEDs

The remote panel and onboard display panel show what is
happening during the charging process and are also helpful in
troubleshooting. Refer to Chapter 3, "Interpreting Fault and
Warning Indicators" on page 3–4 for information about
interpreting the onboard display panel (and the optional
remote panel, if installed) indicator LEDs.

Reporting While Charging or Equalizing

After configuring the charger and during charging, the
onboard display panel (and the optional remote panel, if
installed) will show the following information about the
charger and the battery:
•
•
•
If there is a fault or warning related to one of the banks, the
fault or warning information will display in the form of
illuminating or flashing Fault indicator LEDs. Charging for
all banks will stop and will only resume once the fault
condition is cleared.
975-0401-01-01
DC batteries.
Charging Output Current
Charger Status
Battery Status (optional Remote Panel only)
Accessing Charger Information
2–15