System - Hunter TYPE 3 Installation And Operation Manual

3-1. Find the looped end of the braided cable and insert it through the
ceiling plate and one of the holes in the outlet box into the ceiling.
3-2. Access the support brace in the ceiling. You may not be able to do
this from below the ceiling depending on your installation site.
3-3. Drive a wood screw and washer into the side of the brace that
holds the outlet box. Leave 3mm (1/8") of space between the
support brace and the washer.
3-4. Wrap the braided cable around the support brace once creating a
complete circle.
3-5. Hook the looped end of the cable over the wood screw so that the
braided cable lies between the washer and the support brace.
3-6. Tighten the loop and secure the screw and washer all the way
down to the support brace.
3-7. Coil up the excess cable.
3-8. Return to the fan so you can complete the fan wiring.
Steps 3-2 – 3-3
3mm (1/8")
Support
Brace
Outlet Box
Ceiling
3 • Securing Fan to Secondary Support System
Steps 3-4 – 3-5
Braided
Cable
42659-01 • 02/19/08 • Hunter Fan Company
Step 3-1
6
Steps 3-6 – 3-7