Timer Assembly Replacement - Quadra-Fire 7100FP-BK-B Owner's Manual

Removing the fan
1. Unplug the wire harness.
2. Lift fan from locating pins and remove. Repeat for
second fan if necessary. See Figure 4.9.
3. Connect new fan wires to wire harness.
4. Before installing the fan, make sure the grommets are
tightly in place. Insert the right fan and place over the 2
locating pins. Repeat for other fan. Figure 4.10
5. Re-install bottom panel or firebox access panel in
reverse order as described above.
6 Replace the brick that was removed.
7. Re-install the Fascia and both knobs.
8. Re-install both doors and hinge pins.
9. Reconnect the power.
Remove nut
and lift out fan
Figure 4.9 Fan Motor
Figure 4.10 Installing Fans
4/12

5. Timer Assembly Replacement

Disconnect power by turning off circuit breaker BEFORE
servicing.
1. Remove both doors, outside air knobs, Fascia, and
brick.
2. Remove 2 Phillips head screws and pry open access
door in the bottom of the fireplace with a flat head screw-
driver. Figure 4.11
Figure 4.11
Unplug wire
3. Remove 2 screws and take off access cover. Figure 4.12
harness before
removing fan
Figure 4.12
NOTICE: The timer assembly included in this kit comes
with the air chamber cover attached. Figure 4.13.
4. You will need to disconnect air chamber cover from timer
assembly before installing in the fireplace. Set screws
aside for later use. Figure 4.14 on page 27.
Figure 4.13 Timer Assembly with Air Chamber Cover
433-1390K
CAUTION shock Risk!
Remove 2 screws and
pry open access door.
Open Access Door
Access Cover
Air Chamber Cover is
attached to Timer Assembly
(Linkage arm is not included in the kit)
Page 26