Clear Space Near The Fireplace; Glass Doors; Fan Operation - Quadra-Fire 7100FP-BK-B Owner's Manual

Automatic Combustion
Control Handle
Figure 2.4 General Operating Parts
G. Clear Space Near the Fireplace
Combustible materials must not be stored on the hearth ex-
tension. Room furnishings such as drapes, curtains, chairs
or other combustibles must be at least 4 ft (1219mm) from
the open front of the fireplace.
H. Glass Doors
This fireplace has been tested and listed for use with doors
as specified in Section 12, page 70.
WARNING! Risk of Fire and smoke! Fireplaces
equipped with doors should be operated only with
doors fully open or doors fully closed. If doors are left
partly open, gas and flame may be drawn out of the
fireplace opening.
WARNING! Risk of Fire! DO NOT install and or use
any component not approved by Hearth & Home Tech-
nologies Inc.
4/12
Auxiliary
ACC Override
Convection
Lever
Air Lever
I. Fan Operation
Fan operating instructions with Fan Over-
ride Switch in manual postition
NOTICE: The fan is equipped with a snap disc that will
turn the fan on and off depending on the temperature of the
fireplace. If the fan is not coming on at the desired time,
flip the override switch to manual and operate the fan as
described below.
1. Initial (cold) Startup: Leave fan off until your fire-
2. High Burn Setting: The fan may be left on throughout
3. Medium or Medium High Burn Setting: The fan
4. Low Burn Setting: The fan tends to cool off the fire-
The override switch and the fan speed control are hard wired
at time of installation and installed in a standard wall mount
with junction box on the wall.
433-1390K
Outside Air Control
Handle
(Keep open during use. )
place is hot and a good coal bed is established, ap-
proximately 30 minutes after fuel is lit.
the burn.
should be left off until a good burn is established, then
turned on medium or high rate.
place. Leave fan off until the burn is well established;
then, if you wish, turn the fan on at a low rate.
Page 12