Table of Contents
Advertisement
Hussmann® Impact™ Hot Food Merchandiser
6. Bolt the cases together according to the sequence illustrated below.
Note: Make sure that no more than (2) threads are exposed when the cases are bolted
together. If this does occur, the bolt should be shortened, replaced with a shorter bolt or
capped off according to NSF specifications.
a. Fasten the fronts together using 5/16-18 x 1 Hex Head Cap Screws, 5/16 Flat Washers and
5/16 Lock Washers.
b. Fasten the rear of the cases together at two locations shown above using 5/16-18 x 1
Hex Head Cap Screws, 5/16 Flat Washers, 5/16 Lock Washers and 5/16-18 Hex Nut.
c. Fasten the top rear of the cases together using 5/16-18 x 3 1/2 Cap Screws, 5/16 Flat
Washers, 5/16 Lock Washers and 5/16-18 Hex Nut.
Use caution when installing fasteners around wiring.
19
Installation
Advertisement
Table of Contents
