Table of Contents
Advertisement
Hussmann® Impact™ Hot Food Merchandiser
If the glass is not bottomed out in the clamp hardware it can be re-positioned as follows:
a.
Remove the glass and clamp hardware from the case by opening the glass and loosening
set screws in hinge, (Metric 3 millimeter set screws).
b.
Slide the glass and clamp hardware to the side, out of the hinges, and lay them on an
appropriate work surface.
Note: adjacent glass must be closed.
c.
Loosen the 8 set screws on the underside of the clamp hardware.
d.
Push the clamp hardware onto the glass until bottomed out.
e.
The clamp hardware must overhang the glass by an equal amount on each side.
f.
Tighten set-screws and re-install on case.
4. Slowly open and close the glass to make sure that it is not hitting the end or adjacent glass. If the
glass is hitting the end or adjacent glass it may not be positioned correctly from left to right. This
can be adjusted as follows:
a.
Loosen the 2 screws holding the hinge to the clamp hardware (Metric 3 millimeter screws).
b.
Slide the clamp hardware to either side as needed.
12
Installation
Advertisement
Table of Contents
