Table of Contents
Advertisement
Hussmann® Impact™ Hot Food Merchandiser
4. Remove screws at top of rear doorframe. The bottom screws do not need to be removed.
5. Pull back the top of the doorframe approximately 2 inches. This will allow clearance for removal of
the stainless steel top liner and trim pieces.
6. Some models have a Phillips truss head screw holding the stainless steel liner to the trim. These
screws are visible from the rear of the case to the side of the door frame. These must be
removed.
7. Remove stainless steel top liner by grabbing the rear flange and pulling back. Note: It is possible
to access the adjusting bolt by using a small swivel socket without removing the stainless top
liner. To do this, the stainless steel trim and foam noted in Step 8 must be removed.
8. Remove stainless steel trim pieces and foam insulation on each side of the doorframe.
9. The set screw and adjusting bolt are now accessible.
•
The set screw must be backed out before turning the adjusting bolt, (
set screw serves as a positive stop.
•
The adjusting bolt should be turned no more than a half-turn before inspecting glass position
and operation.
•
Turning the adjusting bolt clockwise will raise the front glass.
•
Turning the adjusting bolt counter-clockwise will lower the front glass.
•
Once the glass position is set, tighten the set screw (positive stop).
14
Installation
/
inch set screw). The
1
8
Advertisement
Table of Contents
