Operation - Soleus Air SG-PTAC-09HPDA Owner's Manual

OPERATION

IMPORTANT: When unit is first started, high humidity conditions can cause condensation to form on
discharge grille. Keep doors and windows closed. Room humidity will decrease and moisture will
evaporate.
TEMP CONTROL
ABOUT THE CONTROLS ON YOUR UNIT
NOTE: In case of a power failure, the unit will remember the last programmed settings and will
restart to those settings.
1. TEMP CONTROL
Temp Control is used to maintain room temperature. Compressor will cycle on and off to keep room at the
requested level of comfort.
COOLER - - Lowers temperature. (Minimum temperature setting is 61_F/16_C)
WARMER - - Raises temperature. (Maximum temperature setting is 86_F/30_C)
2. FAN SPEED, MODE & ON/OFF
FAN SPEED - - Set fan operation for HIGH, MED, LOW or AUTO speed.
MODE- -COOL - - For cooling
MODE- -HEAT - - For heating
NOTE: If unit is a heat pump, raising the heat setting 5_F will cause unit to use its electric heating
elements for one cycle in order to reach the new requested temperature quickly.
MODE- -FAN - - For fan- -only operation
ON/OFF - - Turns the unit on or off.
NOTE: The LED above the ON/OFF button will be green when unit is ON and red when the unit is OFF.
All other LEDs will be off when unit is set to OFF mode.
NOTE: Power remains connected to unit.
FAN, MODE& OPERATION
Fig. 22 – PTAC CONTROLS
14