Related Manuals for Soleus Air SG-PAC-12E1
Summary of Contents for Soleus Air SG-PAC-12E1
- Page 1 Model No. SG-PAC-12E1 SG-PAC-12E1HP (KY-120E1HP) 12,000 BTU Portable Air Conditioner Operating Instructions Reference No. (KY-120E1)
-
Page 2: Important Instructions
Thank you for choosing a Soleus Air Powered by Gree Portable Air Conditioner. This owner’s man- ual will provide you with valuable information necessary for the proper care and maintenance of your new product. Please take a few moments to thoroughly read the instructions and familiarize yourself with all the operational aspects of your new Portable Air Conditioner. -
Page 3: Package Contents
• Dehumidifier mode works when ambient temperatures are between 61°F - 86°F • Air Conditioner mode operates up to an ambient temperature of 95°F. Model Number Reference Number Power Supply (Ph/V/Hz) Dehumidifying Capacity (Pints/Day) -
Page 4: Lcdi Power Cord And Plug
If a test is performed and the indicator light remains ON, current leakage has been detected. Do not use the air conditioner or attempt to reset the LCDI Plug. Contact Soleus Air Powered by Gree Customer Service for trou- bleshooting recommendations. -
Page 5: Product Diagram
PRODUCT DIAGRAM Air Outlet & Louvers Carry Handle Control Panel Filter Upper Air Intake Location Air Exhaust Vent Lower Air Intake Power Cord... -
Page 6: Assembly And Installation
INSTALLATION When the unit is operating as an air conditioner or dehumidifier, the window kit and exhaust hose must be installed. When the unit is operating in fan mode, the window kit and exhaust hose do not need to be installed . -
Page 7: Single Hose Window Kit Installation
SINGLE HOSE WINDOW KIT INSTALLATION This installation is OK The is a poor installation 22” When installing the exhaust hose, try and keep it as flat as possible. The less angles and bends in the hose, the better the unit will perform. If bending or an angle is necessary, use single 90° angles like the pictures above. -
Page 8: Control Panel
CONTROL PANEL SG-PAC-12E1 BUCKET FULL LIGHT MODE BUTTON SG-PAC-12E1HP HEAT MODE LIGHT MODE BUTTON COOL MODE LIGHT DRY MODE LIGHT LED DISPLAY TEMP SELECT BUTTONS COOL MODE LIGHT DRY MODE LIGHT LED DISPLAY TEMP SELECT BUTTONS FAN MODE LIGHT POWER BUTTON... -
Page 9: Control Panel Functions
4) Bucket Full - When the unit cannot evaporate the collected moisture fast enough, the excess water will collect in a backup water tank located inside the unit. The Bucket Full icon (SG-PAC-12E1) or Heat Mode icon (SG-PAC-12E1HP) will light up if this occurs. The unit will then beep 8 times and the LED display will show “H8”. -
Page 10: Fan Button
SG-PAC-12E1HP - / + - / + BUTTONS When the unit is in Air Conditioner or Heater (SG-PAC- 12E1HP) mode you can select your desired temperature. Press the TEMP SELECT buttons (+ or -) to select your desired temperature setting. The temperature on the LCD display on the remote control will increase or de- crease accordingly. - Page 11 TIMER TIMER BUTTON Auto-on Timer: When the air conditioner is off, it can be set to automatically turn on in 30 minutes to 24 hours at the previous set mode and fan setting. To set the Auto- on Timer, press the TIMER button on the unit or remote control.
- Page 12 REMOTE CONTROL OPERATING INSTRUCTIONS REMOTE CONTROL SLEEP SLEEP BUTTON Press the SLEEP mode button to engage SLEEP mode.. This feature limits compressor usage and enhances energy savings by adjusting the set temperature while you are sleeping. Press the SLEEP button once more to disable Sleep Mode. Sleep Mode is not available in Auto or Fan Modes.
-
Page 13: Clean Unit Housing
MAINTENANCE Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any maintenance on the unit. Clean or replace filter - If the air filter is blocked with a dust, the airflow volume may decrease. It is recommended to clean the filter once every two weeks, or as needed. -
Page 14: Troubleshooting
The Air Conditioner displays the Timer hours but does not work The Remote Control is not working POSSIBLE CAUSES The air conditioner is unplugged or not connected well. The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped. - Page 15 TROUBLESHOOTING (CONT.) PROBLEM The LCD Display is showing “E5” The LCD Display is showing “H8” The LCD Display is showing “F1”, “F2”, or “F4” POSSIBLE CAUSES Low Voltage Protection The backup water tank is full Internal malfunction SOLUTIONS • Unplug for 10 minutes and then turn on the unit.
-
Page 16: This Warranty Does Not Cover
One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air Powered by Gree Portable Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of original retail purchase in the United States.