Axis 1620 User Manual page 142

Section 11: Upgrading the Software
142
Upgrading using
AXIS NetPilot
This method is recommended for upgrading the flash memory in
NetWare networks. An Upgrade Wizard is available to guide you
through the necessary procedures.
Follow the instructions below to upgrade your print servers:
1. Obtain the firmware file, using one of the methods presented on
page 139.
2. Put the file in the AXIS NetPilot 'Upgrade' folder. This folder
resides in the same folder as the AXIS NetPilot program and was
created when AXIS NetPilot was installed on your client.
3. Start the Upgrade Wizard by clicking on the Upgrade icon on the
AXIS NetPilot toolbar.
4. Proceed the installation by following the instructions that are
presented to you in the Upgrade Wizard.
If you need more information, please refer to AXIS NetPilot on-line
help.
AXIS 1620 User's Manual