Diamondback 910Sr Owner's Manual page 11

14. Identify the left and right pedals. The ends of the pedal axles are marked with an "L" for left and "R" for right. Install the right pedal
(C‐13R) into the right crank by hand, rotating the axle in a clockwise direction.
15. Thread the left pedal (C‐13L) into the left crank by hand in a counter‐clockwise direction.
16. Use the enclosed pedal wrench to firmly affix the pedals to the cranks. Retighten pedals after approximately ten (10) hours of use.
17. Tighten the left & right crank fixing bolts (C‐22) with the enclosed Allen wrench. Re‐tighten after approximately ten (10) hours of use.
18. Align the rear handlebar assembly (N) with the mounting plate on the seat mast (J). Thread the four Allen bolt and flat washer
assemblies (I‐9 & I‐4) through the handlebar and (N) and into the holes at the base of the seat mast (J). When all bolts are engaged,
tighten firmly with the provide Allen wrench.
19. Plug rear heart rate connector (H‐23) into the pulse wire input jack (N‐4).
910Sr Owner's Manual
11