10
8.
Thread the four (4) Allen bolt and flat
washer assemblies (I‐9 & I‐4) through the
base of the seat back assembly (J) and
into the seat slide assembly (H). Tighten
firmly after all bolts are engaged.
9.
Thread the seat height adjuster knob (M‐
2) into the seat back mount (M) two
turns.
10. While pulling outward on the seat height
adjuster knob, slide the seat back onto
the seat mast (J). Release the knob to
engage the set pin. Ensure the seat back is
indexed in one of the height adjustment
holes. Rotate the knob (M‐2) clockwise to
lock the position.
11. While supporting the seat base (P), thread
the four (4) Phillips screws (I‐11) though
the fore‐aft seat adjustment lever (H‐10)
and into the four threaded inserts located
in the underside of the seat base (P).
Tighten all four (4) bolts.
12. Turn the seat base (P) right‐side up and
align the mounting holes in the underside
of the base with those located in the seat
slide assembly (H).
13. Thread four (4) Allen bolt and flat washer
assemblies (I‐3 & I‐4) through the seat
slide (H) and in the seat base (P). Tighten
all bolts firmly.