Overview; Introduction; Programming Using A Codepad; Table - Bosch CC488 Quick Reference Manual

CC488 | Quick Reference Guide | 1.0 Overview

1.0 Overview

1.1

Introduction

Thank you for choosing the Solution Ultima 880
Control Panel (model CC488) for your installation.
You will find this system extremely flexible, reliable,
and easy to use. This Quick Reference Guide is supplied
with the system to provide users with enough basic
information to wire, configure, and program the
system. Due to the systems many programmable
features and options, we suggest that you obtain the
CC484/CC486/CC488 Installation Manual that
provides detailed information on system options,
functions, and programming methods.
1.2 Programming
The programming options of the system are stored in
a non-volatile EPROM. This memory holds all
information during a total power loss and can be
changed as many times as required.
The entire programming sequence consists of
entering a location number and changing the data as
required.
Use the following methods to program the system:
Codepad
Hand Held Programmer
Alarm Link Software
1.3

Programming Using A Codepad

The system must be disarmed (with no active alarm)
to program the system. If there is an active alarm or
the system is armed, enter the code for User 1
(Default = 2580) followed by the [#] key. (User Code
1 is factory default as the Master Code.)
To enter Installer's Programming Mode, enter the
installer code (Default = 1234) followed by the [#]
key. Two beeps are heard and both the STAY and
AWAY indicators flash simultaneously to indicate
that you entered programming mode. The codepad
indicators displays the current data programmed in
LOCATION 000 (first location of the Primary
Telephone Number).
Bosch Security Systems | 6/04 | 4998152446B
To move to another programming location, enter the
location number followed by the [#] key. The data in
the new location is displayed using the codepad
indicators. (For example, if you enter [3 4 #], the
system jumps to LOCATION 034, the beginning of
the Subscriber ID Number For Receiver 1.)
To move to the next location, press the [#] key. This
steps you to the next location. The data in the next
location is displayed using the codepad indicators.
(For example, if you are currently positioned at
LOCATION 034, pressing the [#] key takes you to
LOCATION 035.)
To step back one location, press the [*] key. (For
example, if you are currently positioned at
LOCATION 35, pressing the [*] key returns to
LOCATION 34.)
To change data in the current location, enter the new
value (0 to 15) followed by the [*] key. This stores the
new data into the location. (For example, if you enter
the value [1 4 *], both the Zone 4 indicator and the
MAINS indicator display to represent the new data
value.)
To move to the next location, press the [#] key. The
data in the next location displays.
To exit Installer's Programming Mode, enter
[9 6 0 #]. Two beeps are heard and the STAY and
AWAY indicators no longer display. The system
returns to the disarmed state and is ready for use.
Table 1 displays a quick guide to programming:
Table 1: Quick Guide to Programming
Task
Enter Installer's Programming
Mode
Exit Installer's Programming
Mode
Step to next Location
Step back one Location
Program new data into
Location
Jump to another Location
EN | 6
Keystrokes
[1 2 3 4 #]
[9 6 0 #]
[#]
[*]
[Data][*] (Data = 0 to 15)
[Location No.][#]