Table of Contents
Advertisement
Repair
Barrel Removal
1. Prepare the gun for service, page 41.
2. Remove the air inlet fitting (35) and take the bracket
(104) off the gun handle (17).
3. Loosen the three screws (11).
CAUTION
To avoid damaging the power supply (18), pull the
gun barrel straight away from the gun handle. If nec-
essary, gently move the gun barrel from side to side
to free it from the gun handle.
4. Hold the gun handle (17) with one hand and pull the
barrel (16) straight off the handle. See F
Barrel Installation
1. Be sure the gasket (10*) and grounding spring (55)
are in place. Make sure the gasket air holes are
aligned properly. Replace if damaged. See F
2. Place the barrel (16) over the power supply (18) and
onto the gun handle (17).
3. Tighten the three screws (11) oppositely and evenly
(about a half turn past snug).
CAUTION
Do not over-tighten the screws (11).
4. Position the bracket (104) on the gun handle (17)
and secure with the air inlet fitting (35).
5. Apply dielectric grease (40) to the exposed inner
tube of the fluid hose (101).
6. Check that the nut (105) is tight on the ferrule hous-
ing (103).
7. Test gun resistance, page 30.
46
104
35
17
Fig. 28. Barrel Removal
. 28..
IG
. 29..
IG
16
Fig. 29. Barrel Installation
11
TI1690A
17
*10
18
11
55
101
104
105
16
TI1691A
35
TI1692A
309293K
Advertisement
Table of Contents
Troubleshooting
