Gun Barrel Removal - Graco Pro Xp H60T10 Instructions Manual

Gun Barrel Barrel Removal Removal
Gun Gun Barrel Removal
1. See Prepare the Gun for Service, page
2. Disconnect the bottom fluid tube nut (N).
Carefully separate the tube assembly (T) from
the bracket (7).
3. Loosen the two screws (6).
NOTICE
NOTICE NOTICE
To avoid damaging the power supply (11),
pull the gun barrel straight away from the gun
handle. If necessary, gently move the gun
barrel from side to side to free it from the gun
handle.
4. Hold the gun handle (16) with one hand and pull
the barrel (1) straight off the handle.
NOTE: NOTE: If the power supply remains in the barrel, NOTE:
remove the alternator/power supply assembly from
the barrel.
Figure 27 Gun Barrel Removal
3A2495K
Gun Barrel Barrel Installation
Gun Gun Barrel
39. 1. Be sure the gasket (5*) and grounding spring
(37a) are in place. Make sure the gasket air
holes are aligned properly. Replace the gasket if
damaged.
2. Make sure the spring (11a) is in place on the
tip of the power supply (11). Liberally
dielectric grease (57) to the tip of the power
supply. Place the gun barrel (1) over the power
supply and onto the gun handle (16).
3. Tighten the two screws (6) oppositely and evenly
(about a half turn past snug, or 20 in-lbs, 2.3
N•m).
To avoid damaging the gun barrel, do not
over-tighten the screws (6).
4. Make sure the fluid filter (10) is in place in the
fluid fitting. Tighten the bottom nut (N) onto the
fitting and torque to 140–150 in-lb (15.8–16.9
N•m). Make sure the top nut remains tight.
5. Follow the steps in
Figure 28 Gun Barrel Installation
Installation
Installation
Liberally apply Liberally
NOTICE NOTICE NOTICE
Test Gun Resistance, page
Repair
32.
43