Gun Barrel Removal; Gun Barrel Installation - Graco Pro Xp 60 AA WB Instructions - Parts Manual

Repair
Gun Barrel Barrel Removal Removal
Gun Gun Barrel Removal
1. Follow the steps in
Prepare the Gun for Service, page
2. Remove the air inlet fitting (21) and take the
bracket (B) off the gun handle (16).
3. Loosen the two screws (6).
NOTICE
NOTICE NOTICE
To avoid damaging the power supply (11),
pull the gun barrel straight away from the gun
handle. If necessary, gently move the gun
barrel from side to side to free it from the gun
handle.
4. Hold the gun handle (16) with one hand and pull
the barrel (1) straight off the handle.
Figure 28 Gun Barrel Removal
46
Gun Barrel
Gun Gun
1. Be sure the gasket (5*) and grounding spring
44. (37a) are in place. Make sure the gasket air
holes are aligned properly. Replace the gasket if
damaged.
2. Make sure the spring (11a) is in place on the
tip of the power supply (11). Liberally
dielectric grease (57) to the tip of the power
supply. Place the gun barrel (1) over the power
supply and onto the gun handle (16).
3. Tighten the two screws (6) oppositely and evenly
(about a half turn past snug).
To avoid damaging the gun barrel, do not
over-tighten the screws (6).
4. Position the bracket (B) on the gun handle (16)
and secure with the air inlet fitting (21).
5. Follow the steps in
Figure 29 Gun Barrel Installation
Barrel Installation Installation
Barrel Installation
NOTICE
NOTICE NOTICE
Test Gun Resistance, page
Liberally apply Liberally
36.
3A2497H