Customization - ATEN CN600 User Manual

CN6000 User Manual

Customization

This configuration dialog allows the Administrator to set Timeout, Login
failure, and Working mode parameters.
An explanation of the Customization parameters is given in the table below:
Time out Control
Login failure
Working Mode
Multiuser Operation Enabling Multiuser operation permits more than one user to log
Reset on exit
26
If the CN6000 doesn't receive any input from a computer that is
accessing it with the Windows or Java client for the amount of
time specified here, it ends the connection.
Login failures allowed, sets the number of consecutive failed
login attempts that are permitted from a remote computer. Login
failure timeout, sets the amount of time a remote computer must
wait before attempting to login again after it has exceeded the
number of allowed failures.
If Stealth Mode is enabled, the CN6000 cannot be pinged. If
Echo Mode is disabled, the CN6000 will not show up in the list
of local CN6000 units. See the CN6000 AP version manual
(provided on the CD that came with this package) for details.
into the CN6000 at the same time.
Placing a check here causes the CN6000 to reset itself and
implement all the new changes when you log out. A wait of
approximately 30 to 60 seconds is necessary before logging in
following the reset.