Customization - ATEN CN-6000 User Manual

Customization

An explanation of the customization settings is given in the table, below:
Uploads After obtaining new versions of the firmware (see p. 13), specify
the directories that you have put them in here to start the firmware
upgrade procedure (see p. 24 for details).
Time out Control If the CN-6000 doesn't receive any input from the computer that
currently has access to it for the amount of time specified here, it
ends the connection so it can be available for other users.
Login failure Login failures allowed, sets the number of consecutive failed
login attempts that are permitted from a remote computer. Login
failure timeout, sets the amount of time a remote computer must
wait before attempting to login again after it has exceeded the
number of allowed failures.
Working Modes If Stealth Mode is enabled, the CN-6000 cannot be pinged.
If Echo Mode is disabled, the CN-6000 will not show up in the
list of local CN-6000 units (see p. 10 and p. 28)
Reset on exit Placing a check here causes the CN-6000 to reset itself and
implement all the new changes when you Click OK and close
the Settings Notebook. Otherwise settings changes will be not
take effect until the CN6000 is manually reset.
The Administrator Utility
2004-05-12
23