Installation - ATEN CS-62U User Manual

Installation

Before you begin, make sure that power to all the
1.
devices you will be connecting up have been
turned off. You must unplug the power cords of
any computers that have the Keyboard Power On
function. Otherwise, the switch will receive power
from the computer.
To prevent damage to your installation due to
2.
ground potential difference, make sure that all
devices on the installation are properly grounded.
Refer to the Installation diagram on the next page as you
perform the following steps:
1. Plug your keyboard, monitor, mouse, into their respective
ports on the CS-62U. The keyboard and mouse ports are
labeled with an icon to indicate which is which.
2. Plug your speakers into the speaker jack on the CS-62U.
3. Plug the USB, video, and speaker connectors of the
attached KVM cables into their respective ports on the
computers you are installing.
Note: The computer attached to the cable with one dot at its
base is the Port 1 computer; the computer attached to
the cable with two dots at its base is the Port 2
computer (see p. 8 for hotkey port selection).
4. Turn on the power to the computers.
Note: The CS-62U's Power On default is to link to the first
computer you turn on.
- 5 -