Table of Contents
Advertisement
SC835 Chassis Manual
Motherboard Installation Procedure
Installing the Motherboard
1. Review the documentation that came with your motherboard. Become familiar
with component placement, requirements, and precautions.
2. Power down the system as described in Section 5-2 and lay the chassis on a
flat surface.
3. Open the chassis cover.
4. Remove any packaging from the chassis. If the rear fans (set of two fans nearest
the I/O slots) or the air shroud is in place, remove them.
5. If required by your motherboard, install standoffs in any areas that do not have
a permanent standoff. To do this, tighten a hexagonal optional standoff into the
chassis.
6. Lay the motherboard on the chassis aligning the permanent and optional
standoffs.
7. Secure the motherboard to the chassis using the rounded, Phillips head screws.
Do not exceed eight lbs of torque when tightening.
8. Secure the CPUs and heatsinks to the motherboard.
Figure 5-6. Installing the Motherboard
5-8
Advertisement
Table of Contents
