Table of Contents
Advertisement
SC835 Chassis Manual
Replacing the Power Distributor
The power distributor provides failover and redundancy. In the unlikely event you
must replace the power distributor, do following.
Installing the Power Distributor
1. Power down the system as described in Section 5-2 and remove the cover.
2. Remove all cable connections from the power supply to the motherboard, back-
plane, and other components. Also, remove both power supplies.
3. Locate the power distributor between the power supply and the fan row.
4. Remove the three screws securing the power supply.
5. Gently pull the power distributor from the chassis. Guide the cables through the
power distributor housing.
6. Slide the new power distributor module into the power distributor housing. Slide
the cables through the bottom of the housing.
7. Reconnect all the power cables, replace the power supply, and insert the plug
into the wall.
Figure 5-14. Removing the Power Distributor
5-18
Advertisement
Table of Contents
